Fuel Pump Driver Module: Notes

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.

Operation Number(s):

NOTE:

Removal steps in this procedure may contain installation details.

Fig 1: Identifying Ignition In OFF Position

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Covers Over Seat Rails

Courtesy of VOLVO CARS CORPORATION

Remove:

covers over seat rails
screws, 4 pcs.

Fig 3: Installing A New Module

Courtesy of VOLVO CARS CORPORATION

Fold up the carpet. Detach the sill trim panel slightly.

Carefully lift up the insulation block and place a block under the insulation block to access the module.

Install the new module and connect the cable connector.

Remove the block and fold the carpet back. Press the sill trim panel into place.

Fig 4: Identifying Covers Over Seat Rails

Courtesy of VOLVO CARS CORPORATION

Install the seat. Use new screws, 4 x M10. Tighten to 50 Nm.