Removing The Sub-Frame: Notes

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bolts, Washers And Brackets In Sub-Frame

Courtesy of VOLVO CARS CORPORATION

Remove and hang up the engine block heater (if applicable) on the left front mounting for the sub-frame
Position a lifting table under the sub-frame
Remove the screws holding the sub-frame brackets to the bodywork on both sides
Remove the four screws from the sub-frame
Carefully lower the sub-frame.
NOTE:
Ensure that the steering gear screws release from the sub-frame.

Fig 2: Hanging Steering Gear From Hook So That Lower Steering Shaft Does Not Come Apart

Courtesy of VOLVO CARS CORPORATION

Hang the steering gear from a hook see 9995045 so that the lower steering shaft does not come apart.