Central Electrical Unit Engine Compartment, Replacing: Installation

INSTALLING THE CONNECTOR 

Press the connector into the holder.

CENTRAL ELECTRICAL UNIT, INSTALLING 

Install: 

• the tie straps for the cables
• the bottom section. Hook into place at the front edge
• the screw in the rear edge. Tighten
• the connector holder. Press into the catch.
  NOTE: The rubber grommet
• the screws
• the engine cooling fan (FC) if applicable
• the intermediate section. Check that all 3 clips have engaged.

FINISHING WORK 

Install: 

• see ENGINE CONTROL MODULE (ECM), REPLACING and TRANSMISSION CONTROL MODULE (TCM), REPLACING
• the cover for the central electrical unit
• the battery negative pole. Also, see BATTERY, DISCONNECTING .