Sun Roof Module (SRM), Calibrating: Calibration

CALIBRATING THE SUN ROOF MODULE (SRM)

Fig 1: Identifying Sun Roof Switch

Courtesy of VOLVO CARS CORPORATION

The sun roof must be closed.

Ignition in position I.

Press the sun roof switch so that the sun roof is in the tilt position. Release the switch.
Press the switch (in the tilt position) in again for at least 5 seconds so that the sun roof closes. Release the switch. The calibration is complete.

NOTE: If the sun roof has not moved to the correct position, carry out calibration again.

HINT: If the sun roof has still not moved to the correct position:

HINT: Press the sun roof switch so that the sun roof moves to the rearmost position (completely open).

HINT: Release the switch.

HINT: Press the switch (in the completely open position) in again for at least 5 seconds so that the sun roof closes.

HINT: Release the switch.

HINT: Close the sun roof and carry out calibration again. See steps, see 1 and 2 above.

For further information on the sunroof, see DESIGN and FUNCTION