Low Stalling Speed

The test conditions described in, see CHECK  above have been met.

Try a new torque converter if the stall speed recorded is below the normal value by more than 300 RPM. 

see TRANSMISSION - REMOVAL, REPLACEMENT AND INSTALLATION

Check the stalling speed again after replacing the torque converter 

If the fault remains, replace the transmission. See TRANSMISSION - REMOVAL, REPLACEMENT AND INSTALLATION

After the check is completed: 

Ignition off.

Remove both the manometer connection and the manometer.

Install: 

• the test plug. Check that the O-ring is undamaged. Replace if necessary. Tighten. See SUMMARY OF TIGHTENING TORQUES FOR SPECIFIC COMPONENTS
• the bracket for the side member
• the holder for the connectors on the bracket
• the cover for the bracket.