LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2005 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Automatic HVAC System) >> Passenger's Mode Control Motor Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Passenger's Mode Control Motor Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Set the passenger's mode to VENT.
  3. Remove the glove box housing (see GLOVE BOX HOUSING REMOVAL/INSTALLATION ).
  4. Remove the throttle actuator control module (see APP SENSOR REPLACEMENT ).
  5. Remove the climate control unit (see CLIMATE CONTROL UNIT REMOVAL/INSTALLATION  ).
  6. Disconnect the 10P connector (A) from the passenger's mode control motor (B). Remove the self-tapping screws and the passenger's mode control motor from the heater unit.
    Fig 1: Identifying 10P Connector And Passenger's Mode Control Motor
    G05462495Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the motor in the reverse order of removal. After installation, make sure the motor runs smoothly.
scientia non olet · About LEMON Manuals