Control Module, Installing On Hydraulic Unit

WARNING: This page is about a different car, the 2019 Audi A5 Sportback and 2018 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Screwdriver :VAG1624

Fig 1: Identifying Torque Screwdriver VAG1624
Courtesy of AUDI OF AMERICA, LLC
ESD Work Surface :VAS6613

Fig 2: ESD Work Surface
Courtesy of AUDI OF AMERICA, LLC
Screwdriver Insert, Bit T25 :VAS5377 , not illustrated

Procedure

Use the complete repair kit when installing.
Protect the ABS control module from bumps or impact. A control module that has fallen to the ground can no longer be used.

The hydraulic unit -4- with the pump motor and the connector -3- faces down.

Fig 3: Identifying Hydraulic Unit
Courtesy of AUDI OF AMERICA, LLC

-- Place the control module -2- carefully from above on the hydraulic unit without tilting.

-- Install the new bolts -1- by hand until the control module touches the hydraulic unit evenly.

If the bolts for the control module on the hydraulic unit are difficult to install or cannot be tightened to the tightening specification, then the hydraulic unit must be replaced.

-- Tighten the bolts in two stages in a diagonal sequence.

-- Install the hydraulic control unit. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .

-- After installing the hydraulic control unit and bleeding the brake system, complete the "Replace" function for the ABS Control Module -J104- /ABS Hydraulic Unit -N55- using the Vehicle Diagnostic Tester => .

Tightening Specifications

Refer to OVERVIEW - CONTROL MODULE AND HYDRAULIC UNIT