Overview - Control Module And Hydraulic Unit
WARNING: This page is about a different car, the 2019 Audi A5 Sportback and 2018 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Control Module and Hydraulic Unit
- Rubber Bushing
- Mounting Bracket
- Bolt
- Tighten in two steps alternating from side to side.
- 1. Step: 1 to 1.5 Nm (to position the seal)
- 2. Step: 2.5 Nm
- ABS Control Module -J104-
- If the ABS Control Module -J104- is faulty, it can be replaced separately.
- If the ABS Hydraulic Unit -N55- is faulty, it must be replaced together with the ABS Control Module -J104-.
- ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING
- Refer to Can be replaced separately if faulty.
- Refer to CONTROL MODULE, SEPARATING FROM HYDRAULIC UNIT
- Refer to CONTROL MODULE, INSTALLING ON HYDRAULIC UNIT
- Brake Line
- To the brake caliper
- Do not change the bending shape.
- Replace a damaged or bent brake line
- 14 Nm
- ABS Hydraulic Unit -N55-
- If the ABS Control Module -J104- is faulty, it can be replaced separately.
- If the ABS Hydraulic Unit -N55- is faulty, it must be replaced together with the ABS Control Module -J104-.
- Brake Line
- From brake master cylinder to the hydraulic unit
- Do not change the bending shape.
- Replace a damaged or bent brake line
- 16 Nm
- Brake Line
- From brake master cylinder to the hydraulic unit
- Do not change the bending shape.
- Replace a damaged or bent brake line
- 14 Nm
- Bolt
- 25 Nm
ABS Control Module -J104-
Fig 2: Identifying Pressure Sensor Contact, Pressure Sensor, Seal, Valve Bodies And Pump Motor Contact
- Pressure Sensor Contact
- Do not touch the contacts
- The illustration depends on the model
- Pressure Sensor
- Must not be changed or damaged
- Cannot be replaced
- The illustration depends on the model
- Seal
- Do not remove or lift
- Cannot be replaced separately
- Valve Body
- Must not be damaged
- Do not use any tools
- Pump Motor Contact
- Must not be damaged