LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1998 >> Forward Control P30, 7.4 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls - Removal & Installation) >> Computerized Engine Controls >> Wheel Speed Signal Module Conditioner Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wheel Speed Signal Module Conditioner Module: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place transaxle in neutral. Remove shifter bezel surrounding gear shift lever by gently releasing it from the attachment clips. Rotate bezel sideways. Place transaxle in park. Turn ignition off. Move front seats to the farthest forward position.
  2. Remove floor console screws and slide console rearward. Remove front console center trim panel by pulling panel rearward at clip location, then disconnect power outlet harness connector and remove panel. Move driver's seat to the farthest rearward position.
  3. Remove steering column filler panel (knee bolster) retainer screws, then pull panel from retainer clips and remove panel. See Figure . Remove front console left trim panel retainer screws and push pin, then remove panel.
  4. Locate wheel speed conditioner module (orange in color similar to a relay) taped to harness that is behind front console trim panel. See Figure . Remove tape and remove module like you would remove a relay.
scientia non olet · About LEMON Manuals