Content Theft Deterrent Arming/Disarming Modes

Enter feature customization mode. See ENTER FEATURE CUSTOMIZATION MODE . Insert a second key into any door lock cylinder. Rotate key to UNLOCK position and hold for one second. Count number of chimes in order to determine current mode (1-3). See CONTENT THEFT DETERRENT SYSTEM ARMING/DISARMING MODES table.

CONTENT THEFT DETERRENT SYSTEM ARMING/DISARMING MODES

Mode	Arms Using Door Lock Cylinder Key	Disarms Using Door Lock Cylinder Key	Arms Using Power Door Lock Switch	Disarms Using Power Door Lock Switch	Arms & Disarms Using Remote Transmitter
1	Disabled	Enabled	Disabled	Disabled	Enabled
2	Disabled	Disabled	Disabled	Disabled	Enabled
3	Disabled	Enabled	Enabled	Disabled	Enabled

To change mode, rotate second key or press PANIC button on remote transmitter (if equipped) to advance to next mode until desired mode is reached, then remove second key. Chime will sound number of times equivalent to mode. Chime indicator sequence will repeat after chime sounds for mode 3. Mode 1 is default mode.
To exit and save current feature customization mode settings, turn ignition switch to OFF position. Install BCM PRGRM (10-amp) fuse. If unable to change content theft deterrent arming/disarming modes, diagnose anti-theft system fault. Perform THEFT DETERRENT DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.