Specifications Index
MONTANA, SILHOUETTE & VENTURE SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut | ||
| Front | 118 Ft. Lbs. (160 N.m) | |
| Rear | 192 Ft. Lbs. (260 N.m) | |
| Battery | BATTERY SPECIFICATIONS | |
| Brakes | ||
| Bleeding Sequence | RR, LF, LR, RF | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 15 psi or specification stamped on cap. | |
| Thermostat R & I | N/A | |
| Water Pump R & I | WATER PUMP REMOVAL | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION TEST No cylinder reading should be less than 689 kPa (100 psi). The lowest reading should not be less than 70 percent of the highest reading. |
|
| Oil Pressure | The oil pressure should be approximately 414 kPa (60 psi) at 1,850 RPM using 5W-30 engine oil. | |
| Overhaul | SPECIFICATIONS | |
| Torque | SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | 52 Ft. Lbs. (71 N.m) | |
| Fuel System | ||
| Pressure Specification | 52-59 psi (358.5-406.8 kPa) | |
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST (3.4L) | |
| Ignition | ||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION and/or appropriate illustration under FIRING ORDER . | |
| Ignition Wires (Resistance) | 3000 Ohms Per Ft. | |
| Ignition Wires (Routing & Coil Pack Identification) | See appropriate illustration under FIRING ORDER | |
| Spark Plug | ||
| Type | AC 41-940 | |
| Gap | .060 In. (1.52 mm) | |
| Torque | 11 Ft. Lbs. (15 N.m) | |
| Starting | ||
| Starter | STARTER MOTOR USAGE | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (136 N.m) | |