Rear Wheel Speed Sensor: Removal
NOTE:
Before proceeding, refer to CAUTION
.
- Raise the vehicle.
- Remove the tire and wheel assembly from the vehicle.
- Disconnect the wheel speed sensor cable connector from the vehicle wiring harness. See Fig 1 . Remove the clip attaching wheel speed sensor cable connector to the vehicle's body.
- Disconnect the wheel speed sensor cable routing clips running along the brake tube, brake hose and axle trailing arm.
- Remove the bolt attaching the wheel speed sensor to the rear disc brake adapter, then carefully remove the sensor head from the rear disc brake adapter and vehicle. See Fig 2 .
CAUTION:
When removing a wheel speed sensor from the rear disc brake adapter, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.