LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2000 >> Durango 5.2 Y >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Verification Test >> Body Verification Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Verification Test

  1. Reconnect all previously disconnected components and connectors. Connect scan tool to Data Link Connector (DLC). If Central Timer Module (CTM) was replaced, turn ignition switch to ON position, then wait 15-30 seconds. If vehicle is equipped with Vehicle Theft Security System (VTSS), use scan tool to enable VTSS. Use scan tool to program any other options as necessary. If Remote Keyless Entry (RKE)/Central Timer Module (CTM) was replaced, program all RKE transmitters and program other options as necessary.
  2. If Powertrain Control Module (PCM) was replaced, it must be programmed with correct VIN and odometer. If PCM is replaced and is not programmed, DTC will be stored in Air Bag Control Module (ACM) and Controller Anti-lock Brake (CAB) module. If DTCs are set in ACM and CAB, enter correct VIN and odometer in PCM. Erase codes in ACM and CAB modules. In addition, if vehicle is equipped with Sentry Key Immobilizer System (SKIS), secret key data must be updated to enable vehicle to start.
  3. If vehicle is equipped with SKIS, obtain secret key data PIN code for vehicle from owner. Connect scan tool to DLC. Go to THEFT ALARM, then SKIM, then MISC. Place SKIM in secured access mode using secret key PIN code for vehicle. Select UPDATE SECRET KEY DATA. Data will transfer from SKIM to PCM.
  4. If Central Timer Module (CTM) was replaced, turn ignition switch to ON position for 15 seconds to learn VIN. If vehicle is equipped with Vehicle Theft Security System (VTSS), use scan tool to enable VTSS. Program customer preference options as necessary. Ensure all doors, hood, liftgate are closed. Open driver's door and remove keys from ignition switch with Remote Keyless Entry (RKE) transponder. Lock all door with RKE transponder. Close driver's door. If VTSS indicator lamp flashes, VTSS is operational. If VTSS light does not flash, diagnose fault. See IDENTIFYING VTSS PROBLEMS  .
  5. Ensure all accessories are turned off. Ensure vehicle battery is fully charged. Turn ignition switch to OFF position, wait 5 seconds. Turn ignition switch to ON position. Read and record DTCs from ALL modules. Erase all DTCs using scan tool. Turn ignition switch to OFF position, and wait 5 seconds. Turn ignition switch to ON position. Operate system that was malfunctioning.
  6. If any DTCs or fault messages are present, refer to appropriate procedure for message displayed or symptoms present. See SYMPTOM INDEX DIRECTORY  table. If system is operating correctly, no DTC is present, and customer's complaint cannot be duplicated, repair is complete.
scientia non olet · About LEMON Manuals