Test SC-3A - Cruise Control Set/Resume Switch

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform TEST SC-1A before proceeding. After each repair, perform TEST SC-VER .

NOTE: For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAM .

Disconnect cruise control SET/RESUME switch. Connect a jumper wire between cruise control switch connector terminals No. 1 (Black wire) and No. 2 (White wire). Using DRB, read cruise control switch voltage. If voltage is less than one volts, replace SET/RESUME switch. If voltage is more than one volt, repair open White wire.