LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2010 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Navigation System) >> Navigation Display Visor Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Navigation Display Visor Removal/Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Do this procedure in a clean place free from dirt.
  • Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).
  • When removing the navigation display visor, do not touch the LCD facing.
  • If there is dirt on the LCD facing, clean it using compressed air.
  • When installing the navigation display visor onto the LCD assembly, be careful not to touch the LCD facing.
  • Check that the navigation display visor and the LCD assembly are properly installed.
  • Since the LCD assembly and the navigation display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.
  • Check that the navigation display unit assembly has no damage.
  • When removing the navigation display visor, do not hold the LCD facing down.
  1. Remove the navigation display unit (see NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION  ).
  2. Remove the screws and the LCD assembly (A) from the navigation display visor (B).
    Fig 1: Locating LCD Assembly And Navigation Display Visor
    G06971237Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the navigation display visor reverse order of removal.
scientia non olet · About LEMON Manuals