Diagnostic Procedure

With CONSULT-II 

1. Turn ignition switch "ON" position. (Do not start engine.)
2. Select "SELF DIAG RESULTS" mode for "A/T" with CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" position and wait at least 10 seconds.
5. Perform DTC confirmation procedure, "DTC CONFIRMATION PROCEDURE ".

Is the "TCM.ROM" displayed again? 

1. Yes : Replace TCM.
2. No : INSPECTION END

Fig 1: Consult II Select Diag Mode Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.