Power Door Lock Test 3A - Left Front Door Fails To Lock
NOTE:
Perform POWER DOOR LOCK TEST 1A
before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAM. See KEYLESS ENTRY & POWER DOOR LOCKS article. Perform TEST VER-1A
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
Disconnect driver's door module 12-pin connector. Using scan tool in ohmmeter mode, probe driver's door module 12-pin connector terminal No. 6 (Orange/Violet wire). If resistance is less than 20 ohms, repair short to ground in Orange/Violet wire. If resistance is 20 ohms or more, replace driver's door module.