LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1998 >> Wrangler SE, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment Specifications & Adjustment Procedures >> Wheel Alignment Procedures >> Toe-In Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Toe-In Adjustment

NOTE: If vehicle is equipped with power steering, engine must be running during entire toe adjustment procedure.
  1. If vehicle is equipped with power steering, start engine. Center front wheels straight ahead. Measure toe and compare to specification. See ALIGNMENT SPECIFICATIONS table.
  2. Center steering wheel by counting turns required to hit left and right steering stops. Center steering wheel midway between stops. Loosen drag link adjustment sleeve clamp bolts. See Fig 1 .
  3. Rotate adjustment sleeve to adjust right wheel toe to specification. See ALIGNMENT SPECIFICATIONS table. Position clamp bolts so threaded bolt ends face as shown. See Fig 1 . Tighten drag link drag link adjustment sleeve clamp bolts to specification. See TORQUE SPECIFICATIONS table.
  4. Loosen tie rod adjustment sleeve clamp bolts at each end of tie rod. See Fig 1 . Rotate tie rod adjustment sleeve to adjust left wheel to toe specification. See ALIGNMENT SPECIFICATIONS table. When adjustment is complete, position sleeve as described earlier, and tighten bolts to specification. See TORQUE SPECIFICATIONS table.
Fig 1: Locating Drag Link & Tie Rod Adjustment Sleeve Clamps (1999 Grand Cherokee Similar)
G96C25488Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals