All Courtesy Lights Inoperative
- Turn ignition off. Remove and inspect fuse No. 8 (15-amp) located in junction block. See Figure. If fuse is blown, go to next step. If fuse is okay, go to step 3.
- Using DVOM, measure resistance between ground and fused B+ terminal (upper terminal) on fuse No. 8 socket. If resistance is less than 5 ohms, repair short to ground in fused B+ circuit. See appropriate wiring diagram in POWER DISTRIBUTION article in WIRING DIAGRAMS. Replace fuse No. 8. Perform BODY VERIFICATION TEST under VERIFICATION TESTS. If resistance is 5 ohms or greater, replace fuse No. 8. Perform BODY VERIFICATION TEST under VERIFICATION TESTS.
- Remove driver's side rear seat overhead reading light lens cover. Using DVOM, measure resistance of Pink wire between fuse No. 8 fused B+ terminal socket (upper terminal) and reading light fused B+ terminal. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or greater, repair open in fused B+ circuit (Pink wire). Perform BODY VERIFICATION TEST under VERIFICATION TESTS.
- Replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION. Perform BODY VERIFICATION TEST under VERIFICATION TESTS.