All Windows Inoperative
- Test circuit breaker. See CIRCUIT BREAKER
under COMPONENT TESTS. If circuit breaker is not okay, replace circuit breaker. If circuit breaker is okay, go to next step.
- Disconnect negative battery cable. Remove driver's side front door trim panel. See DOOR TRIM PANEL
under REMOVAL & INSTALLATION. Disconnect Driver's Door Module (DDM) harness connector C1. Check continuity between ground and terminal No. 8 (Black wire) at DDM harness connector C1. See Fig 1
. If continuity exists, go to next step. If continuity does not exist, repair open in Black wire between DDM and ground point. Ground point is located in left rear quarter panel, near taillight.
- Connect negative battery cable. Turn ignition switch to ON position. Check voltage at terminal No. 9 (Tan wire) at DDM harness connector C1. If battery voltage is not present, repair open in Tan wire between DDM and junction block. If battery voltage is present, repair door module. See DOOR MODULE
under COMPONENT TESTS.
Courtesy of CHRYSLER CORP.