Programming The RFH

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If a Body Control Module (BCM) is also going to be replaced at this time, check the "RF-HUB, BCM, FOBIK REPLACEMENT AND PROGRAMMING ORDER GUIDE" before proceeding. Refer to STANDARD PROCEDURE .

NOTE:

Do not put a laptop or any wireless device (cell phones, audio devices etc.) near the top of the center console (the RKE antenna is located below the center console).

After the RFH has been replaced with new unit, connect the diagnostic scan tool to the Data Link Connector (DLC).
Navigate to the RFH in the "Vehicle View" of the diagnostic scan tool.
With the scan tool select "RFH" and perform the "RF-HUB Replace" routine.
NOTE:
This procedure will require you to log into DealerCONNECT and enter a PIN when requested. The PIN is temporary and will be active for 12 hours. After 12 hours, a new PIN will need to be obtained from DealerCONNECT.
Select "Misc. Function" and perform the "PROXI Configuration Alignment" routine.
Put all the FOBiKs used in this vehicle on the front seat away from the console.
With the scan tool select: "Program ignition FOBIKs" in the Miscellaneous Functions menu and follow the instructions on the screen.
NOTE:
When programming a FOBIK, have it in your hand resting on the console.

NOTE:
When you are instructed to "Press the Unlock button" it is important that you do not hold the button. Press it One time quickly.

NOTE:
This procedure will require you to log into DealerCONNECT and enter a PIN when requested. The PIN is temporary and will be active for 12 hours. After 12 hours, a new PIN will need to be obtained from DealerCONNECT.
After all the FOBIKs have been programmed, turn the ignition on and with the scan tool select "BCM".
Update the Front and Rear Axle Normal Tire Pressure Values.
Program the Tire Sensor IDs.
Turn the ignition to the OFF position, wait 30 seconds, then cycle the ignition back to the ON/RUN position.
Check for any active RFH DTCs. If any are present, perform the appropriate procedure. Refer to DIAGNOSTIC CODE INDEX, RFH
Turn the ignition off and check each FOBiK for proper operation.
Finish the installation procedure (if necessary). Refer to MODULE, RADIO FREQUENCY (RF HUB), INSTALLATION .
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .