Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read ORC DTCs and record on the repair order.
2. Record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read ORC DTCs.
  Did the DTC return?
  
  Yes
  - Go To Next Step
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to: RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK THE PASSENGER SEATBELT BUCKLE
1. Disconnect the Passenger Seatbelt Buckle harness connector.
2. With the scan tool, check if the DTC went from Active to Stored.
  Did the DTC change from active to stored?
  
  Yes
  - Replace the Passenger Seatbelt Buckle in accordance with the Service Information. Refer to BUCKLE, SEAT BELT, REMOVAL AND INSTALLATION .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to: RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Replace the Occupant Classification Module (OCM) in accordance with Service Information. Refer to MODULE, OCCUPANT CLASSIFICATION (OCM), REMOVAL AND INSTALLATION .
  - Perform the Occupant Classification Module (OCM) Verification Test. Refer to: OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST .