LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 3 Mazdaspeed, 2.3 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 609 (Security System And Locks System (Advanced Keyless System)) >> Immobilizer System Component Replacement/Key Addition And Clearing[Advanced Keyless System] >> No. 2 Key Additional Programming Procedure (Using the M-MDS) >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No. 2 Key Additional Programming Procedure (Using the M-MDS): Procedure

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare key 1 for programming.
  2. Start the engine using a valid key or card key.
    CAUTION:
    • Do not place the card key in the vehicle when starting the engine with the valid key, otherwise programming cannot be performed. If the engine is started with the card key, remove the card key from the vehicle after the engine is started.
  3. Verify that the security light illuminates for approx. 3 s  , and then goes out.
  4. Turn the ignition switch to the LOCK position.
  5. Connect the M-MDS to the DLC-2. (See M-MDS CONNECTING PROCEDURE .)
  6. Using key 1, turn the ignition switch to the ON position.
    NOTE:
    • Although the security light flashes and DTC 15 is displayed, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
  7. Select "BODY/SECURITY/PATS functions" from the M-MDS screen menu.
  8. Select "Program additional ignition key" from the M-MDS screen menu.
    NOTE:
    • After selecting the above menu, "operation is successful" is displayed. At this point, the key that turned the ignition switch to the ON position is completely programmed.
    • In this procedure, the necessary number of the keys are completely programmed. To finish the additional key programming, go to Step 13.
    • If additional keys need to be programmed, go to the next step.
  9. Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE[ADVANCED KEYLESS SYSTEM] .)
  10. After verifying that the PATS function menu is displayed again on the M-MDS screen, turn the ignition switch to the LOCK position and remove key 1.
  11. Using the key to be programmed, turn the ignition switch to the ON position.
  12. Return to the Step 6.
  13. After verifying that the PATS function menu is displayed again on the M-MDS screen, select the "Exit (From This Menu)" to finish the M-MDS procedure.
  14. After Step 10, wait 5 s or more  , and then turn the ignition switch to the LOCK position.
scientia non olet · About LEMON Manuals