Diagnostic Procedure
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | PERFORM PCM DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. See DTC TABLE [L5] . See DTC TABLE [MZI-3.7] . |
| No | Go to the next step. | ||
| 2 | INSPECT BATTERY
|
Yes | Recharge or replace the battery, then go to Step 4. See BATTERY RECHARGING [L5] . See BATTERY RECHARGING [MZI-3.7] . See BATTERY REMOVAL/INSTALLATION [L5] . See BATTERY REMOVAL/INSTALLATION [MZI-3.7] . |
| No | Go to the next step. | ||
| 3 | INSPECT GENERATOR
|
Yes | Replace the generator, then go to the next step. See GENERATOR REMOVAL/INSTALLATION [L5] . See GENERATOR REMOVAL/INSTALLATION [MZI-3.7] . |
| No | Go to the next step. | ||
| 4 | VERIFY TROUBLESHOOTING COMPLETED
|
Yes | Replace the auto light/wiper control module, then go to the next step. See AUTO LIGHT/WIPER CONTROL MODULE REMOVAL/INSTALLATION . |
| No | Go to the next step. | ||
| 5 | VERIFY THAT NO OTHER DTCs ARE RECORDED
|
Yes | Go to the applicable DTC inspection. See DTC TABLE [AUTO LIGHT/WIPER CONTROL MODULE] . |
| No | DTC troubleshooting completed. | ||