61 00... Notes for disconnecting and connecting battery

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Observe SAFETY INFORMATIONS FOR HANDLING VEHICLE BATTERY .

Before disconnecting battery

Turn off the ignition and other electrical loads/consumers to prevent sparking when reconnecting.

NOTE: If the ignition is not turned off when the battery is disconnected, fault memories may be set in some control units.

IMPORTANT:

There is a danger of mixing up battery cables: If the battery positive and negative leads are the same color and you are in doubt, follow the polarity to the battery, then mark and cover the leads.
The on-board computer and clock may lose your data.

General notes on disconnecting battery

Do not disconnect battery leads and leads from alternator and starter motor while engine is running.
Disconnect terminal of BATTERY EARTH LEAD from the battery. Cover battery negative terminal(s) and secure.
Disconnect both battery earth leads in version with auxiliary battery. Cover battery negative terminal(s) and secure.
When work is carried out on the electrical system, faults may be caused in the fault memories of some control units when the battery is connected.
When installing battery terminal: Tightening torque 61 21 1AZ .

Only lead AGM battery:

On vehicles with IBS at negative battery terminal:
Do not under any circumstances pull/lever off pole shoes by force.

Do not under any circumstances release socket-head cap screw of IBS.

After connecting battery

IMPORTANT: The scope of application of some systems may be restricted after an open circuit.
Personal Profiles may also be lost.
Settings or activations must be carried out, depending on the equipment specification.
For example:

Activate slide/tilt sunroof, if necessary. See SLIDE/TILT SUNROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) or PANORAMA GLASS ROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .
Activate POWER WINDOW , if necessary