VDC Control Module (VDCCM): Installation

Install in the reverse order of removal.

Tightening torque: Refer to "COMPONENT " of "General Description". <Ref. to VDC CONTROL MODULE (VDCCM) Component, General Description. >

CAUTION: After installation, always make the following two settings.

SRS roll connector and steering angle sensor centering setting
Yaw rate & lateral G sensor 0 point setting These two procedures are required to make the VDCCM recognize what position the vehicle is in later. Refer to Adjustments for the procedures for above settings. <Ref. to ADJUSTMENT VDC CONTROL MODULE (VDCCM). >