LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2006 >> Outback XT, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Security And Locks) >> Keyless Entry System >> Inspection >> Check Buzzer Chirp Setting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Buzzer Chirp Setting

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
BUZZER CHIRP SETTING REFERENCE

Step Check Yes No
1 CHECK BUZZER CHIRP SETTING. 
  1. Check the current setting of the buzzer chirp.
  2. Remove the key from the ignition switch.
  3. Close all doors.
  4. Press the LOCK/ARM or UNLOCK/DISARM button.
 Does the buzzer signal chirp? Buzzer chirp function is OK. Go to step 2. 
2 CHECK BUZZER CHIRP SETTING. 
NOTE: When the operations of steps 1) to 5) are performed while the setting of the buzzer is OFF, the setting of the buzzer turns to ON.
  1. Open the driver's door, and then remove the key from the ignition switch.
  2. Insert the key into the ignition switch while pressing the door lock switch toward UNLOCK side.
  3. Then, within 10 seconds, repeat the pulling out/inserting of the key five times.
  4. Within 10 seconds, close the driver's door.
  5. The setting of the buzzer turns ON <==> OFF, and then the hazard light blinks three times.
    NOTE: If the driver's door is not closed within 10 seconds, the hazard light blinks once. At that time, return to step 1).
  6. Press the LOCK/ARM or UNLOCK/DISARM button.
 Does the buzzer signal chirp? Buzzer chirp function is OK. Check the transmitter function. < Ref. to CHECK TRANSMITTER BATTERY AND FUNCTION  . >
scientia non olet · About LEMON Manuals