Transmission Control Device: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the detent spring to the transmission case.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Fig 1: Identifying Detent Spring
Courtesy of SUBARU OF AMERICA, INC.
Insert the range select lever, and tighten the bolts.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 2: Identifying Range Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Insert the manual plate and parking rod.

Fig 3: Identifying Range Select Lever, Manual Plate, Parking Rod And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Insert the straight pin to the manual plate.

Fig 4: Inserting Straight Pin To Manual Plate
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan and the control valve body assembly. Refer to , INSTALLATION , Control Valve Body.
Install the transmission hanger COMPL.
Tightening torque:

41 N.m (4.2 kgf-m, 30.2 ft-lb)
Insert the transmission connector to the stay.
Install the air breather hose. Refer to , INSTALLATION , Air Breather Hose.
Install the torque converter assembly. Refer to , INSTALLATION , Torque Converter Assembly.
Install the transmission assembly to the vehicle. Refer to , INSTALLATION , Automatic Transmission Assembly.