Knock Control Sensor (FA20): Installation

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.

Installation of knock control sensor
1. Using 2 bolts, install the knock control sensor in the direction shown in the figure.
  Standard value: T=24N.m {245kgf.cm} {17.7ft.lbf}
  
  Fig 1: Locating Knock Control Sensor Installation Position
  Courtesy of SUBARU OF AMERICA, INC.
2. Connect 2 connectors for knock control sensor.
Installation of intake manifold (Refer to INSTALLATION )
Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}