Rear Disc Brake Assembly: Installation
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before installation, remove mud and foreign matter from the disc brake assembly.
- Check each part. <Ref. to INSPECTION , Rear Disc Brake Assembly.>
- Install the support - rear disc brake to the housing assembly - rear axle.
Tightening torque:
66 N.m (6.7 kgf-m, 48.7 ft-lb)
- Install the caliper body assembly.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Connect the brake hose using a new brake hose gasket.
Tightening torque:
Union bolt: 26 N.m (2.7 kgf-m, 19.2 ft-lb)
- Install the parking brake actuator. <Ref. to PARKING BRAKE ACTUATOR , INSTALLATION, Parking Brake Actuator.>
- Bleed air from the brake system. <Ref. to BRAKE LINE , PROCEDURE, Air Bleeding.>
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
- Using the Subaru Select Monitor, exit the brake maintenance mode according to the display screen.
- After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally.
- Install the rear wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)