Security Control Module: Removal
NOTE:
Equipped on C0 and C5 models without keyless access with push button start.
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
- Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>NOTE>BATTERY
.NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
- Remove the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>REMOVAL .
- Remove the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
- Remove the knee airbag module. (Model with knee airbag) Ref. to AIRBAG SYSTEM>Knee Airbag Module>REMOVAL .
- Remove the heater and cooling unit assembly. Ref. to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>Heater and Cooling Unit>REMOVAL .
- Remove the security control module.
- Disconnect the connector.
- Remove the nuts, and remove the security control module.