Check Hazard Light Operation
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK HAZARD LIGHT OPERATION
. Make sure the hazard light blinks when hazard switch is turned to ON. |
Does the hazard light blink? | Go to step 2 . | Check the hazard light circuit. |
| 2 CHECK BODY INTEGRATED UNIT SETTING
. Display the data of «Abnormal warning lamp flashing setting» using Subaru Select Monitor.
NOTE:
For detailed operation procedures, refer to "Application help".
|
Is the setting ON? | Go to step 3 . | Turn the setting to ON. |
| 3 CHECK DATA MONITOR
. Display the data of «Hazard Output» using Subaru Select Monitor. |
Is output signal present when operating the transmitter LOCK/UNLOCK button? | Go to step 4 . | Go to step 5 . |
| 4 CHECK KEYLESS ENTRY OPERATION
. Press the LOCK/UNLOCK button of the keyless transmitter. |
Does it operate properly? | Replace the body integrated unit. <Ref. to BODY INTEGRATED UNIT .> | Check keyless entry system. <Ref. to SYMPTOM CHART , INSPECTION, Keyless Entry System.> |
5 CHECK HAZARD LIGHT CIRCUIT.
|
Is harness normal? | Check body integrated unit. <Ref. to Basic Diagnostic Procedure .> | Repair or replace the harness. |