Inspection Procedure
NOTE:
When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION
).
- CHECK CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (See
DIAGNOSIS SYSTEM
).
Result
RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B
B: GO TO CAN COMMUNICATION SYSTEM (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: Go to Next Step
- Check if the CAN communication system DTC is output (See
DIAGNOSIS SYSTEM
).
- PERFORM ACTIVE TEST USING TECHSTREAM (ABS WARNING LIGHT)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream ON.
- Select Active Test mode and operate the ABS warning light using the Techstream.
ABS/VSC/TRAC
DATA LIST REFERENCETester Display Test Part Control Range Diagnostic Note ABS Warning Light ABS warning light Warning light ON/OFF Observe combination meter - Check that the ABS warning light turns on and off in the combination meter when using the Techstream.
OK: The ABS warning light turns ON and OFF in accordance with the Techstream operation.
NG: GO TO METER/GAUGE SYSTEM (See HOW TO PROCEED WITH TROUBLESHOOTING )
OK: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )