LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2003 >> CTS Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Servicing >> Removal & Installation >> Floor Shift Control >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Floor Shift Control: Removal

  1. Raise and support the vehicle.
  2. Remove the shift control linkage adjustment nut. See Figure.
  3. Disengage the shift control linkage rod from the shift control assembly.
  4. Lower the vehicle.
  5. Remove the shift control boot. See FLOOR SHIFT CONTROL BOOT .
  6. Perform the following procedures to remove the center console assembly:
    1. Remove the shifter trim cover (1).
    2. Disconnect the electrical connector (2) from the shifter trim cover (1). See Fig 1.
    3. Remove the console side trim panels.
    4. Remove the 6 screws (1) securing the console to the floor. See Fig 2.
    5. Remove the console from the vehicle.
  7. Remove the electrical connector (1) from the shift control assembly. See Fig 3.
  8. Disconnect the shift lock actuator electrical connector (2) at the shift control assembly.
  9. Remove the 4 nuts securing the shift control assembly to the tunnel reinforcement. See Fig 4.
  10. Remove the shift control assembly from the vehicle.
Fig 1: Disconnecting Trim Cover Electrical Connector
G00178449Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Console
G00178450Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Shift Control Electrical Connector
G00178407Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing Shift Control Assembly
G00178408Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals