DTC U2100:00 [Advanced Keyless Entry And Push Button Start System]

DESCRIPTION	Incomplete configuration
DETECTION CONDITION	Configuration was not completed.
POSSIBLE CAUSE	Keyless control module configuration error Keyless control module malfunction

DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	PERFORM KEYLESS CONTROL MODULE CONFIGURATION Perform the keyless control module configuration using the M-MDS. (See KEYLESS CONTROL MODULE CONFIGURATION ). Operate the advanced key to activate the keyless control module. Clear the DTC from the keyless control module using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ). Operate the advanced key to activate the keyless control module. Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ). Is the same DTC present?	Yes	Perform the keyless control module configuration again, then go to the next step. (See KEYLESS CONTROL MODULE CONFIGURATION ).
1		No	Go to Step 3.
2	VERIFY TROUBLESHOOTING COMPLETED Operate the advanced key to activate the keyless control module. Clear the DTC from the keyless control module using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ). Operate the advanced key to activate the keyless control module. Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ). Is the same DTC present?	Yes	Replace the keyless control module, then go to the next step. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION ).
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ).
3		No	DTC troubleshooting completed.