Transmission Control Device: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the detention spring to the transmission case.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 1: Identifying Detent Spring
Insert the select lever, and then tighten the bolt.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 2: Identifying Range Select Lever And Bolt
Insert the manual plate and parking rod.

Fig 3: Identifying Manual Plate And Parking Rod
Insert the spring pin to the manual plate.

Fig 4: Identifying Spring Pin To Manual Plate
Install the oil pan and the control valve assembly. < Ref. to INSTALLATION , Control Valve Body. >
Install the pitching stopper bracket.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)
Insert the transmission connector to the stay.
Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >