INA Decoupler
WARNING: This page is about a different car, the 2007 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable.
- Remove generator and accessory drive belt. Refer to REMOVAL .
- Position Special Tool #8823 (VM.1048) into decoupler. See Fig 1.
- Determine if end of generator shaft is hex shaped or is splined. See Fig 2 and Fig 3. If hex is used, insert a 10MM deep socket into tool #8823 (VM.1048). See Fig 4. If splined, insert a 5/16" 6-point hex driver, or a 10MM 12-point triple square driver into tool #8823 (VM.1048). See Fig 5.
- The generator shaft uses conventional right-hand threads to attach decoupler. To break decoupler loose from generator threads, rotate end of tool clockwise or see Fig 4 and Fig 5.
- After breaking loose with tool, unthread decoupler by hand from generator.
| 1 - INA DECOUPLER |
| 2 - TOOL #8823 (VM.1048) |
| 1 - GENERATOR SHAFT |
| 2 - HEX |
| 1 - GENERATOR SHAFT |
| 2 - SPLINES |
| 1 - DEEP 10 MM SOCKET |
| 2 - TOOL #8823 (VM.1048) |
| 1 - DRIVER |
| 2 - TOOL #8823 (VM.1048) |
| 3 - 17 MM WRENCH |