DTC Table [Immobilizer System (Advanced Keyless Entry And Push Button Start System)]

NOTE:

• The security light flashes or illuminates under the following conditions when the ignition is off or ACC.
  • If there is any malfunction:
    • DTC 16 or below: Flashes for approx. 1 min  and the DTC flash pattern indicated in the table below repeats 10 times.
    • DTC 21 or higher: Illuminates for approx. 1 min  and the DTC flash pattern indicated in the table below repeats 10 times.
    • If more than one DTC is detected, only the DTC with the lowest number is displayed.
  • If there is no malfunction:
    • The security light illuminates for approx. 3 s  and then turns off.

DTC TABLE [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)]

DTC						Description	Reference
Security light flashing pattern		Keyless warning light	Push button start warning light	M-MDS display(1)
				Keyless control module	PCM
11		x	x	B10D9:87	P1260:00	Communication error with coil antenna	(See SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
12		x	x	B10D5:13	P1260:00	Coil antenna malfunction	(See SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
13		-	-	B10D7:05	P1260:00	Key ID number error	(See SECURITY LIGHT: 13, DTC: B10D7:05/PI 260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
				B1007:94	P1260:00		(See SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSHBUTTON START SYSTEM)] ).
14		-	-	B10D7:81	P1260:00	Receiving erratic serial data	(See SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
15		-	-	B10D7:51	P1260:00	Unprogrammed key ID number	(See SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
16		-	-	U0100:87	P 1260:00	Communication error with PCM (No response)	(See SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
21		x	-	B10D8:00	P1260:00	Shortage of programmed key	(See SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
22		-	-	B10DA:51	P1260:00	Communication error with PCM (Data transfer failure)	(See SECURITY LIGHT: 22, DTC: B10DA:51/P 1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
23		-	-	B10DA:62	P1260:00	Communication error with PCM (Data mismatch)	(See SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] ).
-		x	x	B10E6:11	-	Short to ground in coil antenna power supply circuit	(See SECURITY LIGHT: NOT ILLUMINATED, DTC B10E6:11/- [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSHBUTTON START SYSTEM)] ).
-		x	x	B10E6:12	-	Short to power supply in coil antenna power supply circuit	(See SECURITY LIGHT: NOT ILLUMINATED, DTC B10E6:12/- [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSHBUTTON START SYSTEM)] ).
-		x	x	U0001:88	U0073.00	Keyless contra) module communication error (HS-CAN)	(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] ).
-		x	-	U0100:00	-	Communication error with PCM
-		x	x	U3000:49	-	Keyless control module internal malfunction	(See DTC U3000:49 [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ).
-		x	x	U3000:96	-	Keyless control module internal malfunction	(See DTC U3000:96 [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ).
(1) The letters at the beginning of each DTC are only displayed when using the M-MDS, and refer to the following: B= Body system, P= Powertrain system, U= Network communication system.
x: Illuminated -: Not illuminated or not applicable